%0 Journal Article %T Simulation and Experimental Validation of Flow-Current Characteristic of a Sample Hydraulic Servo Valve %J Scientia Iranica %I Sharif University of Technology %Z 1026-3098 %A Saadat Foumani, M. %A Sadooghi, M. S. %A Seifi, R. %D 2010 %\ 10/01/2010 %V 17 %N 5 %P - %! Simulation and Experimental Validation of Flow-Current Characteristic of a Sample Hydraulic Servo Valve %K Hydraulic servo valve %K Torque motor %K Pilot circuit %K Spool %K Flow-current curve %R %X This paper presents a novel model to simulate the ow-current characteristic curve of an electro-hydraulic servo valve in steady state condition. This characteristic curve has three major zones: dead zone, linear zone and saturation zone. By using the presented approach, we can simulate the behavior of all types of valves including under lapped, critical center (zero lapped) and over lapped valves. A hydraulic tester has been designed and constructed for validation of the results. It can test the performance of ow-current and some other properties of the valve. Comparison of experimental and simulated curves describes that the model has an acceptable accuracy in determining the four important valve characteristics: ow gain, saturation ow, saturation current and dead zone. As a result, the model can be used for other studies such as geometrical sensitivity analysis (the ultimate objective of this modeling) or design optimization. Since this model is presented in a computer based algorithm, it can be easily used to observe and measure the e ects of change in the parameters of interest (particularly geometrical parameters of the valve) on the ow-current curve. %U https://scientiairanica.sharif.edu/article_3337_e76a676a8cb9fd15f9b2182295996600.pdf